Random Bits of FascinationPosted on by Maria Grace
Mail during the Regency functioned somewhat differently than today’s mail system which influence several of the era’s letter writing practices. Under the Act of 1805 postal rates were determined both by distance and whether the letter weighted a full ounce or was written on one or two sheets of paper. Two sheets of paper cost twice the postage of once sheet and a full ounce was four times! Needless to say, everyday correspondence generally limited itself to one sheet of paper.
The goal would be to get as much as one could on that single sheet of paper. Informal letters often used a small, tight hand and narrow margins to fit as much as possible on that precious single sheet. Similarly utilizing initials instead of names and the abundant use of contractions and abbreviations helped conserve precious literary real estate.
This can be seen in the letter from Jane Austen to her sister Cassandra.
Another frequently used strategy would be to utilize every scrap of space, sometimes in very creative ways, like cross-writing. Once the space was filled writing in the usual direction, the paper might be turned 90 degrees and written over again. Very ambitious souls might also write along the diagonals, getting four pages worth of writing fitted into a single page. (How the recipient might have read that is another matter entirely. It makes my eyes water just thinking about it.)
This letter was only written in two directions and it is a bit mind boggling.
Another clever way to eke out extra space to write was to pay very close attention to how the letter would be folded and write in areas traditionally (and more properly) left blank.
How to Fold a Letter
Common paper used for letters measured approximately 15×19 inches.
This paper was usually folded in half for letter writing, in a configuration like a modern greeting card. The ‘front’ would be left blank for the address while the letter would be written on the two ‘middle pages’ and the ‘back page’.
National Library of Australia, Public domain, via Wikimedia Commons
Writing on that ‘back page’ required a certain amount of caution as the writer should “leave on the middle of the margins of the third page , a space an inch and a half square to receive the wafer or seal . If this be neglected , the wax or wafer must be placed on part of the writing , which will of course be destroyed, thus occasioning blanks in the sense, which have, in many cases been of the greatest importance.“ (Dougall, 1815, p 64)
Following this advice would have avoided this problem in Jane Austen’s letter to her sister.
Addressng the Letter
When it was time to post the letter, the address would be placed in the center of the ‘front page’, with the folded edge at the top.
To seal the letter for the post, the letter would be turned address side down. Then the sides folded in toward the center folding the letter in to thirds. Finally, the bottom would be folded up and the top down over it like a flap. Sealing wax or wafers would glue these edges together to keep the letter private.
folding edges backfolded letter from front, ready to sealplacement of wax or wafer sealextra space hidded from public view by folds
The clever correspondent might notice that additional ‘private’ space might also be found on the ‘front page’ of the letter where folds would take place.
National Library of Australia, Public domain, via Wikimedia Commons
When your letter is sealed , you must write the superscription ( if it be to your superior or equal ) in the following manner, viz . Write the word ‘To’ by itself, as nigh the left-hand upper angle or corner of your letter as is convenient : then begin the title, or name, of the person about an inch lower, and almost in the middle or centre of it, according to the length of the person’s name, or title; and write the place of his abode in a line. by itself at the bottom, in a larger character then the other part, thus :
~The Complete Letter Writer
Since writing the address after it was sealed would probably make the writing difficult to read, it is likely a letter would be written, folded, addressed, then sealed.
Dougall (1815) cautions that “In writing to persons to whom one wishes to mark particular respect, it is customary to inclose (sic) the letter in a cover. In this country however such a letter is considered as double, and consequently charged double postage.” (p64) If an outer wrapper were used, the technique for folding would still be the same.
Next time we’ll have a closer look at the ins, outs, and finer points of how to seal a letter.
Clever ways to save on Regency Era postage — 3 Comments
I have practiced folding paper like that just to see how it looked. I was curious to see if I could do it. I even sent a letter to my friend folded like that. We always try to be creative in our letters and she thought it was a hoot. I even used a wax seal. I had to put it in a larger envelope to protect the wax [just in case]. I don’t think the USPS would appreciate my wax seal breaking or clogging up their equipment. Thanks for sharing. I need to go and find some paper now. I need to practice.
We use cookies to ensure that we give you the best experience on our website. If you continue to use this site we will assume that you are happy with it. To learn more about how our cookies are used visit this page: https://jetpack.com/support/cookies/ Please find our privacy policy here: https://randombitsoffascination.com/contact-me/privacy-policy/OkNoRead more about how cookies are used on this page:
I have practiced folding paper like that just to see how it looked. I was curious to see if I could do it. I even sent a letter to my friend folded like that. We always try to be creative in our letters and she thought it was a hoot. I even used a wax seal. I had to put it in a larger envelope to protect the wax [just in case]. I don’t think the USPS would appreciate my wax seal breaking or clogging up their equipment. Thanks for sharing. I need to go and find some paper now. I need to practice.
I’m curious. Did they ever write on the back side of a sheet of paper, or would the ink bleed through?
If I use a sticker instead of a wax seal, will the postal service accept it as is? Or would it still require an envelope?
Thank you!